HPACUCLI commands

To find HARDWARE RAID and DISK information (For HP servers / Smart Array control card – Need “hpacucli” rpm)+++++++ctrl all showctrl slot=0 showctrl slot=1 logicaldrive all show ctrl slot=1 physicaldrive all show+++++++[root@Server01 root]# hpacucliHP Array Configuration Utility CLI 7.40.7.0Detecting Controllers...Done.Type "help" for a list of supported commands.Type "exit" to close the console.=> ctrl all show
Smart Array 5i in Slot 0 ()
=> ctrl all show status
Smart Array 5i in Slot 0 Controller Status: OK Cache Status: OK
=> ctrl slot=0 show
Controller Smart Array 5i in Slot 0 Bus Interface: pci slot: 0 RAID 6 (ADG) status: False Controller Status: OK Chassis Slot: 1 Hardware Revision: Rev B Firmware Version: 2.58 Rebuild Priority: Low Expand Priority: Low Surface Scan Delay: 15 sec Cache Board Present: True Cache Status: OK Accelerator Ratio: 100/0 (read/write) Read Cache Size: 48 MB Write Cache Size: 0 MB Total Cache Size: 48 MB Battery Backed Cache Size: 0 MB Non Battery Backed Cache Size: 48 MB Battery Pack Count: 0
=> ctrl slot=0 array all show
Smart Array 5i in Slot 0 array A (Parallel SCSI, Unused Space: 0 MB)
=> ctrl slot=0 logicaldrive all show
Smart Array 5i in Slot 0
array A logicaldrive 1 (33.9 GB, 1+0, OK)
=> ctrl slot=0 physicaldrive all show
Smart Array 5i in Slot 0
array A physicaldrive 2:0 (port 2:id 0 , Parallel SCSI, 36.4 GB, OK) physicaldrive 2:1 (port 2:id 1 , Parallel SCSI, 36.4 GB, OK)

---------------

/sbin/hplog -v will show all the Hardware alert logs regarding th HP Server

/sbin/hplog -t -- Display current thermal sensor data

/sbin/hplog -f Display current fan data

/sbin/hplog -p Display current power data

remove blank spaces, tabs and blank lines from file.

tr -d ' \t\n\r' < filename